Ranger 2WD V6-3.0L (2008)
7. Remove the black plastic converter relief valve and spring.
8. Remove the 4 main control valve body check balls.
9. If the main control requires cleaning, completely disassemble the main control. Refer to the main control exploded view in this procedure.
Assembly
1. Thoroughly clean all parts in solvent and blow dry with moisture free compressed air.
2. CAUTION: Do not stone, file or sand the valves. This will remove the anodized finish and may result in further main control or
transmission damage.
After cleaning the main control valve body, carry out the following:
^
Inspect all valve and plug bores for scoring or burrs.
^
Check all fluid passages for obstructions.
^
Inspect all valves and plugs for burrs.
^
Inspect all mating surfaces for burrs or distortion.
^
Inspect all springs for distortion.
^
Check all valves and plugs for free movement in their respective bores.
-
Valves and plugs, when dry, must fall from their own weight into their respective bores.
^
Roll the manual valve on a flat surface to check for a bent condition.