Ranger 2WD V6-3.0L (2008)
14. NOTE: All solenoid electrical connectors must face upward on installation.
NOTE: All shift solenoids are interchangeable.
NOTE: If the TCC valve came out during disassembly, use caution when installing the torque converter clutch solenoid.
Install the SSB, SSD, TCC and EPC solenoids.
1
Install the TCC solenoid.
2
Install the SSB and SSD solenoids.
3
Install the EPC solenoid.
15. NOTE: The solenoid clamp must be installed in the torque converter clutch (TCC) and electronic pressure control (EPC) solenoid grooves, shift
solenoid pockets and the No. 204 plug.
Install the solenoid clamp and the screw.
1
Position the solenoid clamp on the main control valve body.
2
Install the screw.
^
Tighten to 7 Nm (62 lb-inch).
16. NOTE: The shift solenoid electrical terminals must face up on installation.
NOTE: The shift solenoids are interchangeable.
Install the SSA and the SSC shift solenoids.
