Ranger 2WD V6-3.0L (2008)
Wiring Harness: Service and Repair
Internal Harness Service
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect vehicle harness from the transmission case (16-pinch) connector.
3. Drain the transmission fluid.
^
Remove all the transmission fluid pan screws except for 2 in the front. Loosen the 2 front transmission fluid pan screws. Pry the rear of the
transmission fluid pan down and allow fluid to drain. After fluid is drained, remove the front 2 transmission fluid pan screws.
4. NOTE: The transmission fluid pan gasket is reusable. Clean and inspect for damage, if not damaged, the gasket should be reused.
Remove the transmission fluid pan.
1
Remove the transmission fluid pan.
2
Remove the transmission fluid pan gasket.