Ranger 2WD V6-3.0L (2008)
Installation
1. NOTE: Make sure the tab is in the lock position.
NOTE: Install 2 new O-rings on the transmission case (16 pinch) electrical connector.
Install the transmission case (16-pinch) electrical connector.
^
Lubricate the transmission case (16-pinch) electrical connector O-rings with petroleum jelly.
2. Press the transmission case (16-pinch) electrical connector through the case until a click is heard.
3. NOTE: Align the slot on the turbine shaft speed (TSS) sensor electrical connector with the slot in the (16-pinch) case connector.
Install the TSS sensor wire.
1
Install the TSS sensor wire into (16-pinch) case connector.
2
Install the TSS sensor wire into the locator.