Ranger 2WD V6-3.0L (2008)
Inspect the clutch pressure plate levers for heavy wear associated with binding. Also, inspect for substantial difference in lever wear. Inspect the
clutch pressure plate friction surface for scoring, burning, heat checking, distortion, warping and dishing.
^
Install a new clutch pressure plate if any of these conditions are present.
6. NOTE: If necessary, use a suitable cleaning solution to clean the flywheel clutch surface.
Inspect the flywheel for:
^
surface cracks.
^
heat check.
^
glazing.
^
scoring.
^
scratches or grooves.
-
For minor damage, finish the flywheel surface with coarse emery cloth or with a fine grade (400 grit) sandpaper. To polish the surface,
stroke parallel to the machine lines.
7. Inspect the flywheel or ring gear for worn, chopped or broken teeth.
Installation
1. Lubricate the transmission input shaft pilot bearing with grease.
2. Adjust the clutch pressure plate.
1
Using a suitable press, press downward on the fingers until the adjusting ring moves freely.
2
Rotate the adjusting ring counterclockwise to compress the tension springs. Hold the adjusting ring in this position.
3
Release the pressure on the fingers. The adjusting ring will stay in the reset position.
