Ranger 2WD V6-3.0L (2008)
2. Remove the LH cowl side trim panel.
3. Remove the 3 parking brake release bolts.
^
To install, tighten to 2.5 Nm (22 lb-inch).
4. Remove the parking brake control bolts, then position the parking brake control aside.
^
To install, tighten to 20 Nm (15 lb-ft).
5. Remove the retaining ring, then slide the clutch pedal from the clutch and brake pedal support.
6. To install, reverse the removal procedure.
^
Inspect the bushings for wear or damage, install new bushings as necessary.
^
Lubricate the clutch pedal shaft with grease.
