Ranger 2WD V6-3.0L (2008)
4. NOTE: Mark the position of the bearing caps, as arrows may not be visible. The bearing caps must be installed in their original locations and
positions.
Remove the 4 bolts and the 2 bearing caps.
5. CAUTION: Place a wood block between the pry bar and the rear axle housing to protect the machined surface from damage.
Using a pry bar and wood block, pry the differential case from the rear axle housing.
6. Remove and discard the 10 ring gear bolts.
7. NOTE: Care should be taken not to damage the ring bolt hole threads.
NOTE: The anti-lock speed sensor ring cannot be reused once removed.
Insert a punch in the bolt holes and drive off the ring gear and, if necessary, the anti-lock speed sensor ring.
