Ranger 2WD V6-3.0L (2008)
8. Position the differential case assembly, including the bearing cups and shims, in the rear axle housing. Install the 2 differential bearing caps and
the 4 differential bearing cap bolts.
^
Tighten to 112 Nm (83 lb-ft).
9. Position the special tool.
1
Rotate the differential case to make sure the differential bearings are correctly seated.
2
Position the special tool.
10. Rotate the differential case and measure the differential case runout without the ring gear.
^
If runout is less than the specification, install a new ring gear and pinion.
^
If runout exceeds specification, the ring gear is true and the concern is due to either a damaged differential case or differential bearings.
^
Inspect the differential bearings. If the differential bearings are not damaged, install new differential case and differential bearings.
