Ranger 2WD V6-3.0L (2008)
4. NOTE: Mark the position of the bearing caps, as the arrows may not be visible. Always install the bearing caps in their original locations and
positions.
Remove the 4 bolts and the 2 bearing caps.
5. CAUTION: Place a wood block between the pry bar and the differential housing to protect the machined surface or damage to the
component may occur.
Using a pry bar and a wood block, remove the differential assembly from the differential housing.
6. Remove and discard the 10 ring gear bolts.
7. NOTE: Do not damage the differential ring gear bolt hole threads.
NOTE: If removing the anti-lock speed sensor ring, discard it, and install a new anti-lock speed sensor ring during installation.
Insert a punch in the bolt holes and drive off the differential ring gear and, if necessary, the anti-lock speed sensor ring.