Ranger 2WD V6-3.0L (2008)
8. Position the differential assembly, including the differential bearing cups and differential bearing shims, in the differential housing. Install the 2
bearing caps and the 4 bolts.
^
Tighten to 112 Nm (83 lb-ft).
9. Position the special tool.
1
Rotate the differential case to verify that the differential bearings have seated correctly.
2
Position the special tool.
10. Measure and note the differential case runout.
^
If the runout does not exceed the specification, install a new differential ring gear and pinion.
^
If the runout exceeds the specification, the differential ring gear is true and the concern is due to either differential case/differential bearing
damage. Proceed as follows.
11. Remove the 4 bearing cap bolts, the 2 bearing caps and the differential assembly from the axle housing.
12. Using the special tools, remove the differential bearings.
