Ranger 2WD V6-3.0L (2008)
16. Measure the differential case runout.
^
If the runout does not exceed the specification, use the new differential bearings for assembly.
^
If the runout exceeds the specification, install a new differential case.
17. Remove the 4 bearing cap bolts, the 2 bearing caps and the differential assembly from the axle housing.
Installation
Assembly
1. Position the differential ring gear, the anti-lock speed sensor ring and the differential case. Align the bolt holes by starting 2 bolts through the holes
in the differential case and the differential ring gear. Press the new anti-lock speed sensor ring, if removed, and the differential ring gear on the
differential case.
2. Install the 10 new differential ring gear bolts.
^
Tighten to 105 Nm (77 lb-ft).
3. With the pinion depth set and pinion installed, place the differential assembly in the differential housing.
