Ranger 2WD V6-3.0L (2008)
5. NOTE: This step duplicates final drive pinion bearing preload.
Tighten the special tool.
^
Tighten to 2.2 Nm (20 lb-inch).
6. NOTE: The special tool must be offset to obtain an accurate reading.
Rotate the special tool several half-turns to make sure of correct seating of the drive pinion bearings and position the special tool.
7. Install the special tool.
1
Position the special tool.
2
Install the differential bearing caps.
3
Install the 4 differential bearing cap bolts.
^
Tighten to 112 Nm (83 lb-ft).
