Ranger 2WD V6-3.0L (2008)
7. Install the special tool. 1 Position the special tool. 2 Install the 2 differential bearing caps. 3 Install the 4 differential bearing cap bolts. 1 Tighten to
112 Nm (83 lb-ft).
8. NOTE: Drive pinion bearing adjustment shims must be flat and clean.
NOTE: A slight drag should be felt for correct drive pinion bearing adjustment shim selection. Do not attempt to force the drive pinion bearing
adjustment shim between the gauge block and the gauge tube. This will minimize selection of a drive pinion bearing adjustment shim thicker than
required, which results in a deep tooth contact in final assembly of integral axle assemblies.
Use a drive pinion bearing adjustment shim as a gauge for drive pinion bearing adjustment shim selection.
^
After the correct drive pinion bearing adjustment shim thickness has been determined, remove all of the special tools.
9. Using the special tool and a shop press, drive the inner drive pinion bearing and the selected drive pinion bearing adjustment shim until they are
firmly seated on the pinion shaft.
