Ranger 2WD V6-3.0L (2008)
21. Install progressively larger differential bearing shims on the RH side until the largest shim is installed by hand.
22. Install the right side bearing cap and 2 bolts. Tighten the LH and RH bearing cap bolts.
^
Tighten to 112 Nm (83 lb-ft).
23. Rotate the differential carrier several times to verify the differential bearings have seated correctly.
24. Install the special tools and measure the ring gear backlash.
^
If the backlash is within specification, proceed to Step 27.
^
If a zero backlash condition occurs, proceed to Step 25.
^
If the backlash is not within specification, proceed to Step 26.
