Ranger 2WD V6-3.0L (2008)
components to disconnect the driveshaft flange from the pinion flange. Pry only in the area shown with a suitable tool to disconnect the driveshaft
flange from the pinion flange or damage to the component may occur.
Using a suitable tool as shown, disconnect the driveshaft flange from the rear axle pinion flange.
6. Install a Nm (lb-inch) torque wrench on the nut and record the torque necessary to maintain rotation of the pinion through several revolutions.
7. Using the special tool, hold the pinion flange and remove and discard the nut.
8. Index-mark the pinion flange and the drive pinion stem for correct alignment during installation.
