Ranger 2WD V6-3.0L (2008)
6. NOTE: Align the index marks.
NOTE: If new bolts to retain the driveshaft to the axle are not available, coat the threads of the original bolts with Threadlock(R).
NOTE: The driveshaft flange fits tightly on the rear axle pinion flange pilot. To make sure that the driveshaft flange seats squarely on the pinion
flange, tighten the bolts evenly in a cross pattern.
Position the driveshaft flange on the pinion flange with the index marks aligned, and install the bolts.
^
Tighten to 112 Nm (83 lb-ft).
7. Install the brake drums.
8. Install the rear wheel and tire.
