Ranger 2WD V6-3.0L (2008)
3. Clamp the special tool in a vise.
Bearing cup removal
4. NOTE: If necessary, use a pair of pliers to remove a bearing cup that fails to press out all the way.
Remove the bearing cups and the slip-yoke.
1
Position the slip-yoke in the special tool.
2
Press out a bearing cup.
3
Rotate the driveshaft slip-yoke 180 degrees.
4
Press on the spider to remove the remaining bearing cup and the U-joint.
5. Clean the driveshaft slip-yoke.
^
Inspect the driveshaft slip-yoke.
^
Install a new yoke as necessary.
Assembly
Bearing cup installation
1. NOTE: Install the U-joint Kits as complete assemblies only. Do not mix components from other kits.
