Ranger 2WD V6-3.0L (2008)
Bearing cup removal
5. NOTE: If necessary, use a pair of pliers to remove a bearing cup that fails to press out all the way.
Remove the bearing cups and the flange.
1
Position the flange in the special tool.
2
Press out a bearing cup.
3
Rotate the flange 180 degrees.
4
Press on the spider to remove the remaining bearing cup.
5
Remove the flange.
Final disassembly
6. Repeat bearing cup removal in this procedure to remove the remaining bearing cups and the spider from the driveshaft.
7. Clean the yoke area at the end of the driveshaft.
Assembly
Bearing cup installation
1. NOTE: Install the U-joint Kits as complete assemblies only. Do not mix components from other kits.
