Ranger 2WD V6-3.0L (2008)
Installation
1. Lubricate the lip of the wheel bearing oil seal with grease.
2. NOTE: Do not damage the wheel bearing oil seal.
Install the 2 axle shafts.
3. NOTE: Do not damage the rubber O-rings in the axle shaft grooves.
Install the U-washers.
1
Position the 2 U-washers on the button end of the axle shafts.
2
Pull the axle shafts outward.
4. Install the differential pinion shaft.
^
Align the hole in the differential pinion shaft with the case lock bolt hole.
^
Install a new differential pinion shaft lock bolt.
-
Tighten to 30 Nm (22 lb-ft).