Ranger 2WD V6-3.0L (2008)
Fluid - M/T: Service and Repair
Transmission Draining and Filling
1. NOTE: Position a suitable drain pan under the transmission.
Remove the drain plug and drain the transmission.
2. Clean and install the drain plug.
^
Tighten to 48 Nm (35 lb-ft).
3. NOTE: Before removing, clean the area around the filler plug.
Remove the filler plug.
4. NOTE: Fill the transmission with the vehicle on a level surface.
Using a suitable oil suction gun, fill the transmission to the correct level with the specified fluid. The fluid must be just below the fill plug hole.
^
Transmission capacity is 2.6L (2.8 qt).
5. Install the fill plug.
^
Tighten to 48 Nm (35 lb-ft).
