Ranger 2WD V6-3.0L (2008)
7. Reach through the RH access cover opening and remove the wiper motor clip from the RH mounting arm and pivot shaft.
8. Disconnect the (1) RH windshield wiper mounting arm and pivot shaft from the (2) LH windshield wiper mounting arm and pivot shaft, and move
both away from the (3) windshield wiper motor.
9. Remove the RH and LH pivot nuts.
-
To install, tighten to 12 Nm (9 lb-ft).
10. Remove the RH and LH mounting arm and pivot shafts through the RH access opening.
11. CAUTION: To avoid possible damage to the windshield wiper adapter and connecting arm clip, be sure the clip is fully seated before
installing the adapter and connecting the arm clip on the windshield wiper motor crank pin.
NOTE: Be sure to install the RH windshield wiper mounting arm and pivot shaft onto the windshield wiper motor crank pin until it snaps into
place.