Ranger 2WD V6-3.0L VIN V Flex Fuel (2001)
Antenna Cable: Service and Repair
One Piece Cable
REMOVAL
1. Remove the radio chassis.
2. Position the antenna lead-in cable.
1
Open the glove box door.
2
Release the tabs and lower the glove box to the full open position.
3
Disconnect the antenna lead-in cable wire clip.
4
Push the rubber grommet through the sheet metal and feed the antenna lead-in cable through the hole.
3. Remove the radio antenna mast.
^
Remove the radio antenna mast by turning it counterclockwise.
4. Unsnap and remove the radio antenna base cap.
