Ranger 2WD V6-3.0L VIN V Flex Fuel (2001)
Wheel Speed Sensor: Service and Repair
Sensor, Rear
Sensor - Rear
Removal and Installation
1. Raise and support vehicle.
2. NOTE: Clean off dirt and foreign material that may have collected around the rear anti-lock brake sensor before removal.
Remove the rear anti-lock brake sensor.
1
Disconnect the rear anti-lock brake sensor electrical connector.
2
Remove the bolt.
3
Remove the rear anti-lock brake sensor.
3. NOTE: Thoroughly clean the mounting surface. Inspect the anti-lock brake sensor O-ring for damage; lightly lubricate the O-ring with SAE
75W-140 High Performance Rear Axle Lubricant F1TZ-19580-B or equivalent meeting Ford specification WSL-M2C192-A.
To install, reverse the removal procedure.
