Ranger 2WD V6-3.0L VIN V Flex Fuel (2001)
Alignment: Service and Repair
Camber and Caster Adjustment
Camber and Caster Adjustment - 4x2
1. Remove the nuts and alignment plates.
2. Install the cams and the nuts.
3. NOTE: A pry bar can be used between the front suspension arm bushing joint and the frame pocket to aid in moving the arm. When adjusting the
RF camber/caster, adjustment at the RF lower control arm adjustment cam is not recommended.
To increase caster and camber, use the following steps.
1
To increase caster, move the front of the front suspension arm bushing joint outboard and move the rear of the front suspension arm bushing
joint inboard.
2
To increase camber, move the front suspension arm bushing joint outboard equally.
