Ranger 2WD V6-3.0L VIN V Flex Fuel (2001)
Fuel Injector Wiring Harness: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the upper intake manifold.
3. Disconnect the engine control sensor wiring from the Engine Coolant Temperature (ECT) sensor, the water temperature indicator sender unit and
the camshaft synchronizer.
4. Disconnect the Crankshaft Position (CKP) sensor.
5. Disconnect the engine control sensor wiring from the Mass Air Flow (MAF) sensor.
6. Disconnect the engine control sensor wiring from the fuel injectors.
