Ranger 2WD V6-3.0L VIN V Flex Fuel (2001)
2. Install the transmission fluid filter screw.
6. Install the transmission fluid pan.
1. Position a new transmission fluid pan gasket on the transmission fluid pan.
2. Align and install the transmission fluid pan.
^
Loosely install the transmission fluid pan screws.
7. Tighten the transmission fluid pan screws.
^
Use a crisscross sequence to tighten the transmission fluid pan screws.
8. Position the servo heat shield over the servos and clip it to the pan rail.
9. Lower the vehicle.
10. NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms can occur while the vehicle relearns its
adaptive strategy. The customer needs to be notified that they may experience slightly different upshifts either soft or firm and this is a temporary
condition and will eventually return to normal operating condition.
Connect the battery ground cable.
11. Fill the transmission to the correct fluid level and check for correct transmission operation
^
Use MERCON(R) V Automatic Transmission Fluid XT-5-QM or equivalent meeting MERCON(R) V specification.
