Ranger 2WD V6-3.0L VIN V Flex Fuel (2001)
7. Disconnect the solenoid electrical connectors.
1. Disconnect the SSA, SSB, SSC, and the SSD electrical connectors.
2. Disconnect the torque converter clutch (TCC) solenoid electrical connector.
3. Disconnect the electronic pressure control (EBC) solenoid electrical connector.
8. CAUTION: The TCC solenoid and converter modulator valve may pop out of their bore. This may damage the solenoid or converter modulator
valve.
CAUTION: Shift solenoids may pop out of their bore. This may damage the solenoids.
Remove the EBC and SSB solenoids.
1. Remove the solenoid clamp screws.
2. Remove the solenoid clamp.
3. Remove the EBC and SSB solenoids.
9. CAUTION: Do not pry on the other wires or damage the connector case surface.
Disconnect the turbine shaft speed (TSS) sensor electrical connector from the transmission case (16 pin) electrical connector.
1. Disconnect the TSS sensor electrical connector.
2. Remove from the TSS sensor wire locator.
