Ranger 2WD V6-4.0L (2010)
Rear Door Exterior Handle: Service and Repair
Exterior Rear Door Handle
Exterior Rear Door Handle
Removal and Installation
1. NOTE: Use a drift punch to remove the steel centers and a 6.35 mm (1/4 in) diameter drill bit to remove the rivets.
Remove the 2 exterior rear door handle rivets.
2. Position the exterior door handle aside.
3. NOTE: Hold the handle open while removing the barrel ends of the cable.
Disconnect the upper and lower rear door latch actuating cables from the exterior handle.
4. Remove the exterior rear door handle.
5. To install, reverse the removal procedure.
-
Use the special tool to install the rivets.
