Ranger 2WD V6-4.0L (2010)
Hood Latch Release: Service and Repair
Hood Latch Release Handle
Hood Latch Release Handle
Removal and Installation
NOTE: The hood latch control handle and cable are removed and installed as an assembly.
1. Remove the hood latch. For additional information, refer to Hood Latch See: Hood Latch/Service and Repair/Hood Latch.
2. Unclip the hood latch control handle and cable from the inner fender retainer.
3. Unclip the hood latch control handle and cable retainer from the inner fender splash shield.
4. Remove the 2 screws and position the hood latch control handle and cable aside.
5. Remove the hood latch control and cable grommet from the dash panel.
6. Remove the hood latch control handle and cable.
7. To install, reverse the removal procedure.