Ranger 2WD V6-4.0L (2010)
3. Remove the 2 screws and cushion side shield.
-
Pull outward at the side and rear to release the 2 clips (1 shown).
4. Remove the outboard pin-type retainer and position the cushion cover flap aside.
5. Release the hook-and-loop strip at the rear inboard side of the cushion cover.
6. NOTE: Driver seat shown, passenger seat similar.
Release the rear cushion cover J-clip and disconnect the side air bag electrical connector.
7. Detach the retainers and route the side air bag wire harness out through the slot in the cushion cover.
8. Release the J-clip at the inboard side of the cushion cover and access the safety belt buckle and pretensioner.
