Ranger 2WD V6-4.0L (2010)
5. Install the safety belt buckle and pretensioner.
-
Install the safety belt buckle pretensioner and nut.
-
Tighten to 40 Nm (30 lb-ft).
-
Install the wire harness and pin-type retainers as noted in removal.
-
Connect the electrical connectors.
6. Install the cushion cover flap pin-type retainer.
7. Fasten the inboard side J-clip.
8. Fasten the inboard side rear hook-and-loop strip.
9. Install the cushion side shield and 2 screws.
10. Install the recline handle and screw.
11. Install the seat. If a passenger seat has been serviced, do not prove out the SRS at this time. For additional information, refer to front seat Seat
- Front See: Service and Repair/Front Seat/Seat - Front.
12. For passenger seat, carry out the Occupant Classification Sensor (OCS) System Reset. For additional information, refer to the General Procedures
portion of Restraint Systems.
