Ranger 2WD V6-4.0L (2010)
Seat Back: Overhaul
Seat Backrest - Front, Bucket and 40 Percent
Seat Backrest - Front, Bucket and 40 Percent
Disassembly
NOTE: For parts identification and location, refer to Seat - Exploded View, Front See: Service and Repair/Front Seat/Seat - Exploded View, Front.
1. Remove the seat backrest assembly. For additional information, refer to Seat Backrest - Front, Bucket and 40 Percent See: Removal and
Replacement/Seat Backrest - Front, Bucket and 40 Percent.
2. Remove the seat backrest cover. For additional information, refer to Seat Backrest Cover - Front See: Seat Cover/Service and Repair/Seat
Backrest Cover - Front.
3. Remove the backrest foam pad.
4. Detach and remove the side air bag wire harness.
Assembly
1. Route and attach the side air bag wire harness.
2. Install the backrest foam pad to the backrest frame.
3. Install the backrest cover. For additional information, refer to Seat Backrest Cover - Front See: Seat Cover/Service and Repair/Seat Backrest
Cover - Front.
4. Install the seat backrest assembly. If a passenger seat has been serviced, do not prove out the Supplemental Restraint System (SRS) at this
time. For additional information, refer to Seat Backrest - Front, Bucket and 40 Percent See: Removal and Replacement/Seat Backrest - Front,
Bucket and 40 Percent.
5. For passenger seat, carry out the Occupant Classification Sensor (OCS) System Reset. For additional information, refer to the General Procedures
portion of Restraint Systems.
Seat Backrest - Front, 60 Percent
Seat Backrest - Front, 60 Percent
Disassembly and Assembly
NOTE: For parts identification and location, refer to Seat - Exploded View, Front See: Service and Repair/Front Seat/Seat - Exploded View, Front.