Ranger 2WD V6-4.0L (2010)
4. Remove the seat track. For additional information, refer to Seat Track - Bucket and 40 Percent See: Seat Track/Service and Repair/Seat Track -
Bucket and 40 Percent.
5. Detach the pin-type retainer and remove the backrest latch release cable.
-
Note the cable routing for correct installation.
Driver seat
6. Remove the cushion foam pad.
7. Remove the 2 screws and seat position sensor.
Passenger seat
8. Release the 2 wire harness retainers from the seat cushion frame.
-
Note the wire harness routing for correct installation.
9. Release the retainer and pressure sensor from the bracket on the cushion frame.
10. Remove the OCSM.