Ranger 2WD V6-4.0L (2010)
6. Remove the right rear parking brake shoes. See Figure 3.
1. Remove the parking brake shoe holddown springs and anchors.
2. Remove the parking brake return spring and the parking brake shoes.
7. NOTE: The new parking brake actuator should be installed with the pivot and the word "UP" at the top. See figure 4.
Install a new parking brake actuator. See figure 4.
1. Remove and discard the original actuator.
2. Position the parking brake cable extension onto the new parking brake actuator hook so the pivot is located at the top.
3. Position the new parking brake actuator next to the parking brake anchor and secure it with a tie strap.
4. Make sure the new parking brake actuator hook is fully engaged in the parking brake cable extension loop by firmly pulling down on the parking
brake cable extension.
8. NOTE: Do not allow grease oil brake fluid or other contaminants to contact the parking brake shoes.
Using Motorcraft(R) High Temperature Nickel Anti-Seize Lubricant XL-2 or equivalent. lubricate the parking brake shoe contact points on the
backing plate prior to parking brake shoe installation.
