Ranger 2WD V6-4.0L (2010)
Coolant Reservoir: Service and Repair
Coolant Expansion Tank - 4.0L
Removal and Installation
1. Remove the Air Cleaner (ACL). For additional information, refer to Fuel Delivery and Air Induction.
2. If equipped, remove the speed control servo bolt and position the servo aside.
-
To install, tighten to 11 Nm (97 lb-in).
3. Disconnect the windshield washer hose.
4. Disconnect the windshield washer motor electrical connector.
5. Disconnect the overflow hose at the coolant expansion tank and drain the coolant into a suitable container.
6. Remove the 2 bolts, the 2 nuts and the coolant expansion tank.
-
To install, tighten to 7 Nm (62 lb-in).
7. To install, reverse the removal procedure.
