Ranger 2WD V6-4.0L (2010)
5. NOTICE: Avoid scratching or damaging the crankshaft rear seal running surface during removal of the crankshaft rear seal. Scratches
or other damage to the crankshaft may cause oil leaks.
Using the Oil Seal Remover, remove the crankshaft rear seal.
Installation
1. NOTE: The new replacement crankshaft rear seal comes with a speedy sleeve. The speedy sleeve must be installed with the crankshaft rear seal.
NOTE: Be sure the crankshaft rear sealing surface is clean and free of any rust or corrosion. To clean the crankshaft rear seal surface area, use
extra-fine emery cloth or extra-fine 0000 steel wool with metal surface prep.
Lubricate the crankshaft rear seal with clean engine oil.
2. Install the Adapter for 303-579 and the Crankshaft Rear Oil Seal Screws.
3. Position the crankshaft rear seal with speedy sleeve on the Adapter for 303-579 and the Crankshaft Rear Oil Seal Screws.
4. Using the Crankshaft Rear Oil Seal Installer, install the crankshaft rear seal with speedy sleeve.
5. Install the crankshaft spacer.
6. Install the spacer plate.
