Ranger 2WD V6-4.0L (2010)
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Disconnect the battery ground cable. For additional information, refer to Battery.
3. Remove the crankshaft front seal. For additional information, refer to Crankshaft Front Seal See: Seals and Gaskets/Front Crankshaft Seal/Service
and Repair.
4. Drain the cooling system. For additional information, refer to Cooling System &/or Engine Block Heater.
5. Remove the nut and detach the A/C hose bracket from the front cover.
6. Remove the 5 cylinder block cradle-to-front cover bolts.
7. If equipped, remove the 4 bolts and position the A/C compressor and power steering pump bracket aside.
8. Disconnect the generator electrical connections and detach the wiring harness retainers.
9. Remove the bolt and the accessory drive belt tensioner.
10. Remove the 3 bolts and the generator bracket.
11. Disconnect the Crankshaft Position (CKP) sensor electrical connector.
12. Detach the wiring harness retainer.
13. Detach the 2 wiring harness anchors and position the wiring harness aside.
-
Discard the 2 anchors.
14. Remove the bolt and detach the wiring harness from the LH cylinder head.
