Ranger 2WD V6-4.0L (2010)
Blower Motor: Service and Repair
Blower Motor
Removal and Installation
1. Disconnect the speed control actuator electrical connector.
2. Remove the speed control actuator bolt and position the speed control actuator aside.
-
To install, tighten to 11 Nm (97 lb-in).
3. Disconnect the blower motor electrical connector.
4. Remove the blower motor vent tube.
5. Remove the 4 blower motor screws and the blower motor.
6. Remove the blower motor wheel clip.
7. Remove the blower motor wheel.
8. To install, reverse the removal procedure.