Ranger 2WD V6-4.0L (2010)
2. Install the RCM fuse 8 (10A) to the SJB and install the RH lower cowl trim panel.
3. WARNING: Make sure no one is in the vehicle and there is nothing blocking or placed in front of any air bag module when the battery is
connected. Failure to follow these instructions may result in serious personal injury in the event of an accidental deployment.
Connect the battery ground cable.
4. Prove out the SRS as follows:
Turn the ignition from ON to OFF. Wait 10 seconds, then turn the ignition to ON and monitor the air bag warning indicator with the air bag
modules installed. The air bag warning indicator will light continuously for approximately 6 seconds and then turn off. If an SRS fault is present,
the air bag warning indicator will:
- fail to light.
- remain lit continuously.
- flash (RCM not configured).
The air bag warning indicator may not illuminate until approximately 30 seconds after the ignition has been turned from the OFF to the ON
position. This is the time required for the RCM to complete the testing of the SRS. If the air bag warning indicator is inoperative and a SRS fault
exists, a chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag warning indicator and any SRS fault discovered must be
diagnosed and repaired.
Clear all continuous RCM and Occupant Classification System Module (OCSM) DTCs using a scan tool.
