Ranger 2WD V6-4.0L (2010)
Headlamp Dimmer Switch: Service and Repair
Steering Column Multifunction Switch
Removal and Installation
1. Remove the ignition switch lock cylinder. For additional information, refer to Doors, Hood and Trunk &/or Locks.
2. If equipped, remove the tilt release lever/ handle.
3. Remove the 3 steering column shroud screws and the upper and lower steering column shrouds.
4. Disconnect the multifunction switch electrical connectors.
5. Remove the 2 screws and the multifunction switch.
-
To install, tighten to 3 Nm (27 lb-in).
6. To install, reverse the removal procedure.
