Ranger 2WD V6-4.0L (2010)
4. Remove the 3 screws and the SJB.
Installation
NOTE: When a new SJB is installed, all customer Remote Keyless Entry (RKE) transmitters may be required to be present in order to program the
RKE transmitters to the new SJB.
1. Install the SJB.
-
Install the 3 screws.
-
Connect the electrical connectors.
2. NOTE: If the SJB was not replaced, this is the last step that is necessary.
Install the RH lower cowl trim panel.
3. NOTE: When successful, this step provides the calibration necessary for the SJB operation and clears DTCs B106D and B2477. The clearing of
these DTCs indicates the calibration data has been successfully downloaded to the new SJB.
NOTE: When successful, this step also programs the remote transmitters into the new SJB. In the event the remote transmitters do not program to
the new SJB, all of the remote transmitters need to be present. Refer to Doors, Hood and Trunk &/or Locks, Remote Keyless Entry Transmitter
Programming. This action programs the remote transmitters into the new SJB.
Download the SJB configuration information from the scan tool into the new SJB. For additional information, refer to Information Bus. See:
Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless Entry/Keyless Entry Transmitter/Testing and Inspection
4. NOTE: When successful, this step clears DTCs B2868, B2869, B2870 and B2871. The clearing of these DTCs indicates the SJB has recognized
the tire pressure sensors during the training procedure.
Train the tire pressure sensors. For additional information, refer to Wheels and Tires.
5. NOTE: DTC C2780 does not clear if any other DTCs are present in the SJB. When successful, this step clears DTC C2780.
Carry out the SJB self-test (must be an on-demand) by clearing DTCs, and then retrieving DTCs to confirm all DTCs have been cleared.
