Ranger 2WD V6-4.0L (2010)
1. Remove the RCM fuse 8 (10A) from the SJB.
2. Disconnect the battery ground cable and wait at least one minute. For additional information, refer to Battery.
3. Under the rear of the driver seat, connect the seat side air bag module electrical connector, slide and engage the locking clip.
4. Under the rear of the front passenger seat, connect the seat side air bag module electrical connector, slide and engage the locking clip.
5. Connect the passenger air bag module electrical connector.
6. Install the driver bag module. For additional information, refer to Driver Air Bag Module See: Air Bag Systems/Air Bag/Service and
Repair/Driver Air Bag Module.
7. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Supplemental
Restraint System (SRS) Depowering and Repowering.
