Ranger 2WD V6-4.0L (2010)
Dimmer Switch: Service and Repair
Instrument Panel Dimmer Switch
Removal and Installation
1. Remove the audio unit. For additional information, refer to Accessories and Optional Equipment.
2. Remove the center instrument panel finish panel.
-
Remove the 2 screws.
-
Disconnect the electrical connectors.
3. Remove the 2 bolts and position aside the hood latch release handle.
4. Remove the 2 screws and remove the instrument panel steering column cover.
5. Remove the 5 bolts and the lower instrument panel reinforcement.
-
To install, tighten to 11 Nm (97 lb-in).
6. If equipped, position the column-mounted transmission range selector lever to the lowest position.
7. Remove the Instrument Cluster (IC) finish panel.
-
Remove the 5 screws.
-
Disconnect the electrical connectors.
8. Remove the 2 screws and the instrument panel dimmer switch.
9. To install, reverse the removal procedure.
