Ranger 2WD V6-4.0L (2010)
Throttle Position Sensor: Service and Repair
Throttle Position (TP) Sensor - 4.0L
Throttle Body (TB) Cover
Throttle Position (TP) Sensor
Removal and Installation
1. Remove the 3 bolts and the Throttle Body (TB) cover.
-
To install, tighten to 8 Nm (71 lb-in).
2. Disconnect the Throttle Position (TP) sensor electrical connector.
3. NOTICE: Failure to remove the Throttle Position (TP) sensor screws in the following manner will result in damage to the screws. First,
loosen the screws 1 to 2 full turns using a hand tool, and then use a suitable high-speed driver to complete the removal.
Remove and discard the 2 bolts and the TP sensor.
