Ranger 2WD V6-40L (2010) - Steering Gear Service and Repair (Page 4502)
7. Remove the steering line clamp plate nut and disconnect the pressure and return lines.
-
Discard the O-ring seals.
-
To install, tighten to 35 Nm (26 lb-ft).
8. Plug or cap the return line, pressure line and the steering gear ports to prevent the entry of dirt.
9. NOTICE: Hold the tops of the steering gear studs to avoid damaging the steering gear fluid transfer tubes.
Remove the 2 steering gear nuts and the 2 steering gear studs.
-
To install, tighten to 150 Nm (111 lb-ft).
10. Remove the steering gear.
11. If necessary, remove the outer tie-rod ends.
12. NOTICE: New O-ring seals must be installed any time the power steering lines are disconnected from the steering gear or a fluid leak
may occur.
To install, reverse the removal procedure.
-
Install new power steering line O-ring seals and cotter pins.
13. Fill the power steering system. For additional information, refer to Steering.
14. Check and, if necessary, adjust the front toe.
