Ranger 2WD V6-4.0L (2010)
5. Install the stabilizer bar link assembly in the following sequence.
1. Install the stabilizer bar link stud and grommet.
2. Install a new stabilizer bar link nut and grommet.
-
Tighten to 35 Nm (26 lb-ft).
6. Remove the Coil Spring Compressor.
7. Position the shock absorber and install 2 new shock absorber lower nuts.
-
Tighten to 25 Nm (18 lb-ft).
8. Install a new shock absorber rod nut and washer.
-
Tighten to 48 Nm (35 lb-ft).
9. Position a suitable jack under the lower arm and raise the suspension until the index marks on the lower arm and the frame are aligned (curb
height).
-
Tighten to 200 Nm (148 lb-ft).
10. Remove the jack from under the lower control arm.
