Ranger 2WD V6-4.0L (2010)
6. NOTICE: The filter has a bypass valve in it. The red arrow on the filter indicates the direction of the transmission fluid flow through the
filter. The filter must be installed in the transmission fluid cooler tube with the red arrow pointing away from the transmission fluid
cooler and toward the transmission (the return transmission fluid cooler tube has fluid coming out of the cooler going to the
transmission). If the filter is not installed correctly, it will cause internal transmission damage.
NOTE: Do not install any rubber hoses or tubing with a bend entering the filter greater than 60 degrees.
Using a suitable length of hose(s), install the filter. Tighten the clamps.
7. Connect the lower transmission fluid cooler tube nut.
-
Tighten to 28 Nm (21 lb-ft).
8. Install the retainer clips on the transmission fluid cooler tubes.
9. Clean a section of the transmission fluid pan and install the sticker.
10. Fill the transmission with transmission fluid.
-
Verify for correct operation.
-
Check the filter for leaks.
Transmission fluid in-line filter with an auxiliary transmission fluid cooler
