Ranger 2WD V6-4.0L (2010)
Clutch Master Cylinder: Service and Repair
Clutch Master Cylinder and Reservoir
Clutch Master Cylinder and Reservoir
Removal and Installation
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In
the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data
Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. NOTE: Clean the area around the quick disconnect coupling.
Using the Hydraulic Line Disconnect Tool, disconnect the hydraulic tube from the clutch slave cylinder.
3. Remove the 2 screws and the lower steering column finish panel.
4. Remove the 5 bolts and the lower reinforcement panel.