Ranger 2WD V6-4.0L (2010)
Universal Joint: Service and Repair
Driveshaft Universal Joint - Single Cardan, Slip Yoke
Driveshaft Universal Joint - Single Cardan, Slip Yoke
U-Joint
Disassembly
Initial disassembly
1. NOTICE: Do not, under any circumstance, clamp the shaft in the jaws of a vise or similar holding fixture. Denting or localizing fracture
may result, causing shaft failure during vehicle operation.
NOTICE: Because the driveshaft is precisely balanced, even a slight dent can cause noise and vibration.
Place the shaft on a suitable workbench. Do not damage the tube.
2. Remove and discard the 2 snap rings.
3. Clamp the C-Frame and Screw Installer/Remover in a vise.
