Ranger 2WD V6-4.0L (2010)
Flex Plate: Removal and Replacement
Flexplate
Removal
1. Remove the transmission. For additional information, refer to Automatic Transmission/Transaxle &/or Transmission Control Systems.
2. Remove the 8 bolts and the flexplate.
-
Discard the bolts.
Installation
1. NOTE: New flexplate bolts must be installed. They are a torque-to-yield design and cannot be reused.
Install the flexplate. Tighten the 8 new bolts in 3 stages in the sequence shown.
-
Stage 1: Tighten to 13 Nm (115 lb-in).
-
Stage 2: Tighten to 50 Nm (37 lb-ft).
-
Stage 3: Tighten an additional 90 degrees.
2. Install the transmission. For additional information, refer to Automatic Transmission/Transaxle &/or Transmission Control Systems.
